TECHNICAL SHEET
MINI Serie
MINI A 24
Industrial Rotary Switch
MINI Serie
MINI A 24 Model
TECHNICAL DRAWING AND CHARACTERISTICS

 

General characteristics :

Electrical characteristics :

  • Angle between 2 positions: 15°-30°-45°-60°-90°-120°
  • Max. panel thickness: 6
  • Sealing joints on request
  • Max. operating temperature : dry heat: +85°C
  • Min. operating temperature : dry cold: -55°C
  • Insulation: alkyd
  • Switches with solid silver contacts
  • Diameter of the cable hole:
    • in contact blades: 1.5 mm
    • in pole-pieces: 1.7 mm
  • Max. voltage: 200V
  • Max. current:
    • with cut: 1 A
    • without cut: 5 A
  • Max. breaking power: 80 W
  • Contact resistance: 0.01 miliohm
  • Dielectric strength:
    • between non shorting contacts: 3500 Vdc
    • between contacts and pole pieces: 3500 Vdc
    • between contacts, pole pieces and ground: 3500 Vdc
  • Insulation resistance:
    • between two adjacent contacts: 5.10^6 Megaohm
    • between contacts and ground: 1.10^6 Megaohm
Dimensions, cotes L
Standard assembly
Shortened assembly
Simple wafer
Double wafer
Simple wafer
Double wafer
1 wafer
34
53
34
53
2 wafers
57
90
53
86
3 wafers
79
127
71
119
4 wafers
102
164
90
152
5 wafers
124
201
108
185
6 wafers
147
238
127
218
Par galette supplémentaire ajouter:
22.5
37.1
18.5
33.1

Nota:
Where more than 6 wafers are stacked, add the length given above for each additional wafer
Principal combinations available per stator face according ti angular gap
Angle between two positions
15°
30°
45°
60°
90°
120°
Number of poles
1
2
3
4
6
8
12
1
2
3
4
6
8
1
2
3
4
6
1
2
3
4
1
2
3
1
2
Number of positions
24
12
6
8
4
3
2
12
6
4
3
2
2
8
4
3
2
2
6
3
2
2
4
2
2
3
2
Important:
  • The stops are user adjustable from 2 to 20 positions
  • Availlable with 24, 12, 8, 6, 4 and 3 positions on a full turn
    • Version CC: Shorting contacts, (make before break)
    • Version E: Panel sealing, add 2mm to L
    • Version M: Navy quality with or without sealing
    • Version SP: Solder terminals are replaced by solder pins for PCB mounting
    • Version R: Straigth terminals to reduce L
  • Other versions:
    • Gold plated contacts 3µ over nickel plating
    • Improved insulation to 5 or 8 KVDC between poles and ground
    • Open circuit
    • Make before break on the positions not utilised
    • Activation by RONIS or KABA key
    • Assembly with counter-turning indexing
    • Hollow shaft (diameter 6 x 3,1 o diameter 10 x 6,1) for mounting with other components (switch, potentiometer)
    • Standard shafts and special shafts
    © IEC Electronique - Juillet 2001 -